Roland PNC-950 Instrukcja Użytkownika Pobierz pdf (Strona 16)

If You Are Using a Flat Sheet

- Ideally, the PNC-950 should be set up as shown in figure A or B below. If you are using a different setup configuration

(like in figures C, D, and E), then it will not be possible to feed the sheet correctly.

- Be sure to use a sheet with a thickness (sheet and base paper) of 0.2 mm (about 0.008") or more.

- Do not use a sheet that has any of the following problems:

- Bent or torn edge - Exposed and soiled adhesive - Peeling, shrinking or exposed base paper

A: OK B: OK C: No good D: No good E: No good

(1) Lower the sheet loading levers to raise the movable pinch rollers on the left and right, and move each of the pinch rollers all the way

to its respective side.

(2) Pass the end of the sheet between the pinch rollers and the grit rollers so that it extends through the unit.

(3) Move the sheet from side to side and align the left edge of the sheet with the guide lines to the front and rear of the grit rollers.

Make sure at this time that both edges of the sheet lie over the grit rollers. (See “Reference -- Sheet Loading Position” on page 8.)

(4) Move the left and right movable pinch rollers to the two edges of the sheet. If a pinch roller does not move easily, it may help to

grasp the corresponding pinch roll frame (refer to illustration of step (3) ) at the back of the unit and move it together with the pinch

roller.

(5) After positioning the pinch rollers, raise the sheet loading levers at the rear of the unit to lower the pinch rollers and secure the sheet in

place. Do not put the pinch rollers on the end of the sheet when doing this.

(6) Press the SETUP key.

The tool carriage moves to the cutting origin point. (After scanning the sheet size, the cutting origin is set at the bottom left corner

of the sheet.) At this time, check the output sheet to make sure it is free of offset and alignment problems, diagonal feed problems,

and pinch roller handling problems. If there are any problems, the sheet was not loaded straight.Reload the sheet so that it is aligned

straight.

Movable pinch roller (left)

Sheet

Guide line

Front of the

PNC-950

Sheet

Sheet loading lever

Pinch roll frame

Guide line

Back of the

PNC-950

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Brak uwag

Roland PNC-950 Instrukcja Użytkownika Strona 16