Roland PNC-950 Instrukcja Użytkownika Pobierz pdf (Strona 11)

4 BASIC OPERATION

4-1 Setting Up and Connection

• Setting Up

When arranging setup space for the PNC-950, make sure you have a space that is at least 905 mm (35-11/16") wide, 500

mm (19-11/16") in depth, and 220 mm (8-11/16") in height.

Since the sheet moves during cutting, make sure the unit is placed on a stable, sturdy surface. Also make sure there is

nothing that can block the sheet at both front and rear.

Avoid installing the PNC-950 in the following conditions, as this may result in damage to the machine.

• Avoid places subject to strong electrical noise.

• Avoid excessively dusty or dump places.

• Never leave the unit in a place that is subject to direct sunlight, or where the temperature could go to extremes.

• Since it is normal for this device to emit heat when in operation, never place it where it is poorly ventilated and such

heat cannot dissipate.

• When Moving the PNC-950...

Do not try to pick up or move the PNC-950 by grasping the top area of the unit -- be sure to use both hands to grip the

PNC-950 securely on the left and right sides.

• Connection

* Always make sure that the power is off on both the computer and the PNC-950 whenever any cables are

connected or disconnected.

Power cord

Parallel input connector

Serial input connector

Serial connector

parallel connector

Cables are available separately. One which you are sure matches the model of computer being used should be selected.

When the PNC-950 is connected to the computer via the serial port, the communication parameters (Baud, Data, Parity,

Stop, etc.) for the PNC-950 need to match the port settings on the computer. Use the DIP switches on the right-hand side

of the PNC-950 to make these settings. Refer to "4-2 DIP Switch Settings" to make the correct settings.

Parallel interface cable

Serial interface cable

Power

connector

Power outlet

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Brak uwag

Roland PNC-950 Instrukcja Użytkownika Strona 11