Roland VS-1680 Instrukcja Właściciela Pobierz pdf (Strona 36)

Switching Track Conditions

The condition for each track switches each time the

STATUS button is pressed. You can check the condi-

tion by looking at the button indicators.

SOURCE (orange):

Allows you to monitor the input source or track

assigned to each channel.

REC (blinking red):

Specifies what is recorded to each track. In playback,

tracks are monitored. You can directly specify what is

to be recorded by pressing the STATUS button while

holding down [REC].

PLAY (green):

Plays back each track. You can directly specify what is

to be played back by pressing the STATUS button

while holding down [STOP].

OFF (darkness):

The track is muted (silent).

* The VS-1680 can record up to eight tracks simultaneous-

ly. Thus, you cannot specify the track condition of

REC or SOURCE for more than eight tracks.

Changing the Current Time

The current playback time in the display is shown in

SMPTE time code. The current measure, beat, and

Marker number are also displayed. Use the following

procedure to change the current playback time.

SMPTE Time Code (Appendices p. 65)

1. Press [PLAY (DISPLAY)].

2. Hold down [SHIFT] and press [ ].

The time display is framed in bold lines.

fig.02-06a(smpte.eps)

3. Use the [ ] and [ ] buttons and the

TIME/VALUE dial.

When using the TIME/VALUE dial, time playback

time moves according to the position of the cursor.

With the cursor moved to the subframe position, rotat-

ing the TIME/VALUE dial moves the time point in

increments of 1/10 of a frame. To move the time in

1/100-frame increments, hold down [SHIFT] while

rotating the TIME/VALUE dial.

Moving to the Beginning or End of the

Performance

You can move directly from within any of the V-tracks

in the currently selected track to the first or last loca-

tion in the song that contains recorded sound. Use the

following procedure.

To go to the first location in the song containing

recorded sound:

Hold down [SHIFT] and press [SONG TOP (REW)].

To go to the last location in the song containing

recorded sound:

Hold down [SHIFT] and press [SONG END (FF)].

fig.02-06b(songtop.eps)

Storing a Time Location

With the VS-1680, there are two ways you can mark

and easily recall sections of a song that you want to

record over or listen to repeatedly. One is called the

Locator function, and the other one is referred to as

the Marker function. Use each method according to its

intended function.

Locator:

Store “locator,” or time locations to the LOCATOR

([1]–[8]) buttons on the top panel of the VS-1680. Each

button correspond to each time in a one-to-one corre-

spondence, and you can move instantly to the location

with the press of the corresponding button. There are

eight banks for each button, providing you with up to

64 (8 x 8) locators.

Marker:

Up to 1000 locate points (000–999) can be set in rapid

succession in each song. You can also store Auto Mix

data (p. 157), and there is a sync track provided as well

(p. 136).

Hour Minute Second Frame Sub Frame Measure Beat Marker Number

Cursor

Song Top Song End

Chapter 2 Basic Operation

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 211 212

Komentarze do niniejszej Instrukcji

Brak uwag

Roland VS-1680 Instrukcja Właściciela Strona 36

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Instrumenty muzyczne Roland VS-1680