Roland VS-1680 Instrukcja Użytkownika Pobierz pdf (Strona 124)

Cromatic Formant

Adjust the formant of the voice character in semitone

steps.

Fine Formant

Make fine adjustments to the formant of the voice

character.

MixBal (Mix balance)

Adjust the balance between the voice character vol-

ume and the normal voice volume.

FE (Fader Edit)

This switch allows you to use the channel faders of the

top panel to modify the various settings of the Voice

Transformer.

Sw (Switch)

Turn the Feder Edit on/off. If this is on, channel faders

will control the following settings.

Channel 1: EFX1:Robot (Moving the fader above

the middle will turn this on, and

downroad will turn it off.)

Channel 2: EFX1:C.Pitch+F.Pitch (Cromatic Pitch

and Fine Pitch will change simultane-

ously to smoothly change the pitch.)

Channel 3: EFX1:C.Formant+F.Formant

(Cromatic Formant and Fine Formant

will change simultaneously to smooth-

ly change the pitch.)

Channel 4: EFX1:MixBal

Channel 5: EFX1:EfxLev

Channel 8: EFX3:Robot (Moving the fader above

the middle will turn this on, and

downroad will turn it off.)

Channel 9/10: EFX3:C.Pitch+F.Pitch (Cromatic Pitch

and Fine Pitch will change simultane-

ously to smoothly change the pitch.)

Channel 11/12: EFX3:C.Formant+F.Formant

(Cromatic Formant and Fine Formant

will change simultaneously to smooth-

ly change the pitch.)

Channel 13/14: EFX3:MixBal

Channel 15/16: EFX3:EfxLev

* Fader Edit is valid only when you are in Effect Edit con-

dition. In other conditions, the faders will control the vol-

ume level of each channel as usual. Also, it will fail to

operate in Auto Mix (Owner’s Manual p. 156).

MIDI (MIDI control)

* The MIDI channels on which the pitch and formant are

adjusted are fixed respectively as below. They cannot be

changed to other channels.

Sw (Switch)

Turn MIDI control on/off. When this is on, MIDI note

on messages and pitch bend messages will adjust the

pitch and formant. This is effective when a MIDI key-

board etc. is connected.

MIDI channel 1: EFX1:C.Pitch+F.Pitch (C2–C6, orig-

inal key is C3)

MIDI channel 2: EFX1:C.Formant+F.Formant

(C2–C4, original key is C3)

MIDI channel 3: EFX3:C.Pitch+F.Pitch (C2–C6, orig-

inal key is C3)

MIDI channel 4: EFX3:C.Formant+F.Formant

(C2–C4, original key is C3)

PitchBend (Pitch bend)

Specify the maximum change produced by pitch bend

(bend range), in semitone steps.

Portament (Portamento)

Specify the speed at which the portamento effect will

change.

Vocoder 2

This is a 19 band vocoder. A clear sound that was not

possible with conventional vocoders can be obtained.

Input an instrumental sound into the left channel, and

a voice into the right channel.

Envelope (Envelope)

Sharp: The human voice will be emphasized.

Soft: The instrumental sound will be emphasized.

Long: A vintage sound with long decay will be produced.

PanMode

Select Mono, Stereo, L→R or R→L. With a setting of

Mono, the components of each frequency band will be

located in the center. With a setting of Stereo, the odd-

numbered frequency bands will be located at the left,

and the even-numbered components at the right. With

a setting of L→R, the low frequency bands will be

located increasingly toward the left, and the high fre-

quency bands will be located increasingly toward the

right. With a setting of R→L, the low frequency bands

Function of Each Effect Parameter

124

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 135 136

Komentarze do niniejszej Instrukcji

Brak uwag

Roland VS-1680 Instrukcja Użytkownika Strona 124

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Instrumenty muzyczne Roland VS-1680